It seems that my Tunze Osmolator Nano has given up the ghost again. Tunze replaced the pump for me a few months ago as it stopped pumping water.

Back in the spring, the problems started. The ATO stopped pumping, and instead would make a clicking sound until I power cycled the whole ATO - at which point it would start pumping again.

I was in touch with Tunze who shipped me a replacement pump. It worked fine for a few weeks and then it started doing the same thing. However, after about a week, it stopped pumping altogether, even if I unplugged/replugged.

I have reached out to Tunze again and hopefully they will be able to assist.
View October 12, 2015 22:20
New phone! Has a much better camera than my last phone, so I took a bunch of photos.
View September 29, 2015 22:19
Called Ecotech support and managed to figure out the issue with the Reeflink. Everything is connected and running well!
View September 17, 2015 15:56
Mounted UPS on the wall and tidied cables. Also set up ATO and cleaned the outside of the glass.
View September 14, 2015 22:38
Measured salinity - was way too low. Dumped a bunch of salt in, re-measured and went to pick up my livestock that was being boarded at my LFS!
View September 12, 2015 22:39
Filled aquarium the rest of the way
View September 10, 2015 22:39
Rinsed and added sand and added dry rock. Half-filled aquarium with saltwater. Verified it was still level.

Added some equipment: Reeflink, Radio, and Vortech.
View September 9, 2015 23:37
Finally, a use for the flooring scraps: shimming the aquarium. It blends with the floor well too.

It is not completely level left to right, and has about a 1/4cm drop back to front.

Picked up a BRUTE 32 and started mixing saltwater.
View September 8, 2015 23:35
No leaks from the plumbing; not bad for my first time. Noticed that the tank is not level - drops about 1cm right to left and back to front.

Drained the tap water and will cut some wood to shim up the stand.
View September 7, 2015 23:34
Tap-water leak testing!
View September 6, 2015 23:34